Cottonwood Heights Foundation Pros
Driveway Lifting in Cottonwood Heights, UT
Driveway lifting in Cottonwood Heights, UT: polyjacking raises sunken concrete driveways and restores proper slope. Free estimates available.
- 15+ Years local experience
- 500+ Projects completed
- Licensed & Insured
Serving Cottonwood Heights and nearby communities.
A driveway that's sunk near the garage or settled at a slab joint isn't just a cosmetic problem, it's usually directing water toward the house instead of away from it. Driveway lifting uses polyurethane foam injected through small drill holes to raise sunken sections back to grade, restoring the slope that keeps runoff moving away from the foundation.
Cottonwood Heights Foundation Pros sees this most on bench-area driveways where soil settles unevenly along the slab's length, especially near the garage apron where loads concentrate. Polyjacking handles this without the extra weight or longer cure time of an older cement-based lift.
Materials
Materials and methods for Driveway Lifting
What goes under and over the slab determines how long the fix holds.
Polyurethane Foam
Provides lift without adding the heavy load back onto soil that's already settling unevenly beneath the driveway.
Concrete Patch Mix
Seals the drilled access holes so the repaired spots match the surrounding slab.
Joint Sealant
Reseals expansion joints that get disturbed when a slab section lifts and shifts slightly.
Surface Sealer
Guards the driveway against the moisture cycling and freeze-thaw stress common on the bench.
Leveling Equipment
Confirms slope direction during the lift so water runs toward the street, not toward the garage.
Bonding Primer
Improves how well the patch material bonds to the original slab for a durable repair.
Questions on materials?
Get a Free EstimateHow it works
How our Driveway Lifting process works
Step 1Driveway Inspection
Sunken or sloped sections are measured and the correct slope direction is confirmed.
Step 2Access Drilling
Small holes are drilled at points chosen to lift the section evenly.
Step 3Foam Injection
Expanding foam is pumped beneath the slab in controlled stages.
Step 4Slope Correction
Elevation is adjusted so water drains away from the garage and foundation.
Step 5Hole Sealing
Drilled holes are patched to blend into the existing driveway surface.
Step 6Surface Review
The driveway is checked for even grade and proper drainage direction.
Timeline
How long does a Driveway Lifting take?
Most driveway lifting jobs wrap up in a single visit, with the slab usable again the same day.
- 01
Consult and measurement
same day - 02
Drilling and injection
half dayfor most driveways
- 03
Foam cure time
15 minutes
- 04
Patch and joint sealing
same visit
- 05
Driveway ready for vehicle use
same day
Need a schedule that fits?
Get a Free EstimateWhat's included
What's included with Driveway Lifting
Typically included: drilling, foam injection, slope correction, hole patching, joint resealing.
Optional: full driveway sealant coating, additional lift on adjoining walkway slabs.
Customer prep: move vehicles off the driveway and clear any items stored on the slab before the crew arrives.
Want a clearer scope?
Get a Free EstimateCodes & permits
Permits and codes for Driveway Lifting
Check with Salt Lake County or Cottonwood Heights city if your driveway project involves work near the public street or curb.
| Typically needs a permit | Often no permit |
|---|---|
| Driveway work that alters the curb cut or connects to a public right-of-way | Standard foam injection lifting of an existing residential driveway slab |
Need help with permits?
Get a Free EstimateCost
What does a Driveway Lifting cost in Cottonwood Heights?
Cost depends on how much of the driveway has settled and how far it needs to lift. Ask for a free estimate and we'll walk the driveway with a level before naming a figure.
| Project type | Typical range | What’s included |
|---|---|---|
| Single slab section | $500–$1,200, | one sunken panel or joint area. |
| Full driveway apron | $1,200–$3,000, | the section nearest the garage or street. |
| Entire driveway (multiple slabs) | $3,000–$7,000, | full-length settlement correction. |
These are typical local ballparks — final cost depends on scope, materials, and site conditions. A free estimate gives you an accurate, itemized number for your home.
Want a number for your home?
Get a Free EstimateDIY vs pro
DIY vs hiring a pro for Driveway Lifting
| DIY | Hire a pro |
|---|---|
| Sealing a hairline surface crack with concrete caulk | Injecting foam in the right pattern to lift a slab evenly without cracking it |
| Filling small surface spalls or chips | Restoring proper slope so water actually drains toward the street |
| Keeping gutters and downspouts clear so water doesn't pool near the driveway edge | Diagnosing whether settlement will continue without a drainage fix alongside the lift |
Not sure DIY vs pro?
Get a Free EstimateWhen to call
When to call for Driveway Lifting
Call for a free estimate before a sunken driveway starts directing water toward your foundation.
- The driveway has sunk near the garage door threshold
- Water pools on the driveway instead of running toward the street
- A slab joint has become a visible trip or vehicle hazard
- Soil has washed out or settled visibly along one edge of the driveway
Seeing warning signs?
Get a Free EstimateFAQs
Driveway Lifting FAQs
How much does it cost to lift a sinking driveway in Utah?
Most residential driveway lifting runs $500 to $7,000 depending on how much of the driveway has settled, with single-slab repairs on the lower end.
How long does driveway lifting take?
Most jobs are finished in a few hours to half a day, and the driveway is usable again the same day once the foam cures.
Is polyjacking better than mudjacking for a driveway?
Yes for most residential driveways. Polyurethane foam is lighter, cures faster, and doesn't reload the soil the way a cement slurry mix does.
Do I need a permit to lift my driveway?
Standard slab lifting on an existing residential driveway usually doesn't need a permit. Work affecting the curb cut or public right-of-way might.
Can I lift a sunken driveway myself?
Lifting itself isn't a practical DIY job since it requires injection equipment and volume control. Sealing small cracks is fine to handle yourself.
Will my driveway sink again after lifting?
It can if the underlying soil settlement or drainage issue isn't addressed, which is why we check grading around the slab as part of the job.
What causes a driveway to sink near the garage?
Concentrated loads from vehicle traffic combined with soil settlement under the apron are the most common cause, especially on bench-grade lots with clay soil swings.
More services
Other Foundation Repair services
Foundation Repair
Foundation repair in Cottonwood Heights, UT: push piers, helical piers, and crack injection with free estimates.
Piering and Underpinning
Push pier and helical pier underpinning in Cottonwood Heights, UT, for settling foundations on bench-grade clay and fill soil. Free estimates.
Wall Stabilization
Bowing basement wall stabilization in Cottonwood Heights, UT using wall anchors and carbon fiber straps. Free estimates, written scope.
Ask about Driveway Lifting
Tell us about the project and how to reach you.